Lathe
Motor Power (Lathe)	1HP(750W), Single-Phase, 110V, 60HZ
Swing Over Bed	16-8/15''(420mm)
Swing Over Cross Slide	11-1/2"(120mm)
Distance Between Centers	15-3/4''(400mm)
Bed Width	5-5/16''(135mm)
Spindle Bore	11/14''(20mm)
Spindle Mount	Flange mount
Spindle Type	Integrated Spindle
DIA of the chuck	4''(100mm)
Spindle Taper	MT3
Tailstock Taper	MT3
Tailstock Quill Travel	2-3/4''(70mm)
Carriage Travel	15''(380mm)
Carriage Leadscrew Diameter	25/32"(20mm)
Cross Slide Travel	4-8/11''(120mm)
Compound Slide Travel	3''(76.2mm)
Spindle Speed Range	160-1360RPM
Number of Speed Ranges	7
Longitudinal Feed Rate	0.002''-0.007'' in/r
Transverse Feed Rate	NO
Leadscrew Size & Pitch	20mm 6TPI
Threading Capacity – Inch	8-120TPI
Threading Capacity – Metric	0.2-3mm
Thread Dial Indicator	NO
Maximum Tool Bit Size	1/2''x1/2''(12x12mm)


Drill/Mill
Motor Power (Mill Head)	Powered by the lathe's motor
Mill Taper	MT3
Spindle Speed Range	117, 150, 220, 276, 290, 345, 360, 440, 450, 575, 640, 836, 1000, 1300
Number of Speed Steps	14
Spindle Travel	3-11/32"(85mm)
Drawbar Thread Size	3/8''(9.52mm)
Drawbar Length	10-3/4''(273mm)
Drawbar Thread Pitch	16TPI
Drill Capacity	19/32''(15mm)
End Milling Capacity	25/32"(20mm)
Face Milling Capacity	2-1/2"(63mm)
Vertical Travel (Z-Axis)	3-5/32''(80mm)
Distance: Spindle to Table	15-3/4''(400mm)
Distance: Spindle to Center Line	9-3/4''(248mm)
Headstock Height	3''(76.2mm)
Head Tilt Angle	0°
Swivel angle of the headstock	360°
Drive Type	Belt-driven AC Motor
Overall Dimensions	41''x23''x43''(1050x580x1090mm)
N.W/G.W	408/463lbs(180/210kg)

WARNlNG: This product can expose you to chemicals including engine exhaust (including diesel engine exhaust when equipped),lead and lead compounds, mineral oils, soots, phthalates, and carbon monoxide which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Certain specification(s) are based on engineering calculations and are not actual measurements. Specification(s) are provided for comparison purposes only and are subject to change without notice. Specification(s) for your individual equipment will vary based on normal variations in design, manufacturing, operating conditions, and other factors.

Centre Lathes

1 HP 16''x16'' Multi-Function Metal Lathe Milling Machine Head for Metalworking Combo Lathe, Drilling, and Milling Operations with Powerful Motor, Perfect for DIY, Workshops, and Professional Combination Metalworking Projects without Stand CLM1620